Intel D865GLCLK BIOS

The following defines how the Intel D865GLCLK motherboard bios should be set up.

Important: use bios version P24 or later (as specified on the bios Main menu). If your bios is not up-to-date, please update first according to Intel’s directions.

To enter the bios program you must attach a PS/2 keyboard and VGA-compatible monitor to the system (the motherboard has on-board video). As the system starts up, hit the Delete or F2 key to enter the bios.

Depending on the current bios confiuration, you may find that you need to “Exit Saving Changes” at certain points, re-enter the bios, and continue. For example, if USB Boot is disabled, then you will first have to enable it and then re-boot so that the bios “sees” the USB Flash Drive on the Boot menu.

The following describes the settings for each menu page. The proper setting is shown in [brackets].

Main

• Language [English]
• System Time []
• System Date []

Advanced

PCI Configuration

• PCI Slot1 IRQ Priority [AUTO]
• PCI Slot2 IRQ Priority [AUTO]
• PCI Slot3 IRQ Priority [AUTO]

Boot Configuration

• Plug & Play O/S [No]
• Numlock [On]

Peripheral Configuration

• Serial Port A [Disabled]
• Parallel Port [Disabled]
• Audio [Disabled]
• Onboad LAN [Enabled]
• ASF Support [Enabled]

Drive Configuration

• ATA/IDE Configuration [Enhanced]
• PCI IDE Bus Master [Enabled]
• Hard Disk Pre-Delay [Disabled]

Floppy Configuration

• Diskette Controller [Disabled]

Event Log Configuration

• Event Logging [Enabled]

Video Configuration

• AGP Aperature size [64MB]
• Primary Video Adapter [AGP]
• Frame Buffer Size [1MB]

USB Configuration

• USB Function [Enabled]
• High-Speed USB [Enabled]
• Legacy USB Support [Enabled]
• USB 2.0 Legacy Support [Hi-Speed]

Chipset Configuration

• ISA Enable Bit [Disabled]
• PCI Latency Timer [32]
• Extended Configuration [Default]

Fan Control Configuration

• Fan Control [Enabled]
• Lowest Fan Speed [Slow]

Security

• Chassis Intrusion [Disabled]

Power

ACPI

• ACPI Suspend State [S3 State]
• Wake on LAN from S5 [Power On]

• After Power Failure [Power On]
• Wake On PCI PME [Stay Off]

Boot

• Silent Boot [Disabled]
• Intel (R) Rapid BIOS Boot [Disabled]
• PXE Boot to LAN
• USB Boot [Enabled]

Boot Device Priority

• 1st Boot Device [see note below]

Hard Disk Drives

• 1st Drive [see note below]

Removeable Devices

• 1st Drive [see note below]

Exit

• select Exit Saving Chages

To setup up USB Boot, first ensure the Advanced/USB Configuration is correct. Then go to either the Removeable Drives menu, or the Boot/Hard Disk Drives menu; select the 1st Drive (and press Enter), and arrow down to select the USB Flash drive. After having done this, the Boot/Boot Device Priority should now show the USB Flash Drive as the 1st Boot Device.